AJA V2Analog Specifications download pdf (Page 57)

Ki Pro Installation and Operation Manual — CONFIG menus

8.1 TC VALUE

This parameter selects an hour for timecode to start.

8.2 TC TYPE

This parameter selects drop frame or non-drop frame timecode.

8.3 ARM RECORDING

This parameter selects how recording will begin: either by pressing record button (or

web “Record” button) or via timecode. If starting on timecode, parameters 8.0, 8.1. and

8.2 must be set to qualify the source and type of timecode.

35.2 9-PIN REMOTE

Ki Pro RS-422 control is enabled or disabled in the CONFIG menu parameter 35.2 9 Pin

Remote via Local Only or Remote Only parameter settings.

Once "Remote Only" has been selected, the CONFIG menu parameter 8.0 TC In will

default to "RS422". This change allows Ki Pro to accept in-point timecode values for an

edit as the beginning timecode value for a recording. Example: the value 01:00:00:00 is

entered, this becomes the ﬁrst frame of the Ki Pro recording.

Note: Not all RS-422 controllers send timecode values to devices over 9-pin. If the controlling

device does not send a timecode value by RS-422, another timecode source may be

selected in the CONFIG menu parameter 8.0 TC In.

IMPORTANT: Ki Pro can be used as a player or a recorder under RS-422 operation, but

when used as a recorder, Ki Pro can only perform assemble edits, not insert edits. This

means that Ki Pro creates a new ﬁle for each assemble edit performed; Ki Pro cannot

insert into an existing ﬁle.

Ki Pro can operate on a solitary clip under RS-422 control or all of the clips on the

Storage Module. Whether one clip or all clips are active under RS-422 is determined by

the MEDIA menu parameter 15.1 Play Media. IMPORTANT: Ki Pro may react erratically if

invalid clips or media are present and 15.1 Play Media "All" is selected.

Note: Ki Pro RS-422 device control under a single clip is designed so that the clip may be

obtained in it's entirety via non-linear capture. This is made possible because Ki Pro

produces video black/silence prior to the ﬁrst frame of video for the single clip and after the

last frame of video for the single clip. This means that unlike video tape where you might

not have sufﬁcient pre-roll to ingest a take into a non-linear editor, Ki Pro allows you to

obtain the whole clip by marking the in-point for ingest as the very ﬁrst frame of video

recorded.

8.1 TC VALUE 1 to 23 Use the ADJUST buttons to select a timecode hour.

For example:

01:00:00:00,

“02:00:00:00, etc.

8.2 TC TYPE NDF (default)

Selects Non-drop Frame timecode

Selects Drop Frame timecode

8.3 ARM RECORDING REC KEY

TC/REC KEY (default)

Start Record button is pressed

Start on Time Code or Record button

35.2 9 PIN REMOTE Local Only (default)

Remote Only

Selects Ki Pro control under front panel or web UI

Selects RS422 control of Ki Pro

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 89 90

Comments to this Manuals

No comments

AJA V2Analog Specifications Page 57

Comments to this Manuals