AJA V2Analog Specifications download pdf (Page 50)

22.1 GANG CLIP NAME

This parameter is used when performing gang recording via multiple Ki Pros (refer to

Controlling Multiple Ki Pros later in this manual). If the desire is to have clips named

the same across all Ki Pro ganged units' recordings, then use the "Master Name"

selection in this parameter. If the desire is to have clips named independently on Ki

Pro units, then "Slave Name" should be selected. Selecting "Slave Name" means that

the recording will take it's name from the individual Ki Pro's parameters and not

accept the value pushed to the Slave by the Master Ki Pro.

CONFIG menus

When we talk about menus, we discuss the Parameter Number and Name on the top

line of the display and the Parameter Setting(s) possible as shown on the bottom line

of the display; remember, the current setting is what is shown.

As in the MEDIA menus already presented, pressing one of the parameter Adjust

buttons changes the current CONFIG parameter’s value to a new one from the Ki Pro’s

list of choices—repeating the list if you continue to press Adjust—or adjusting a

numerical value up or down.

The exact choices displayed will vary depending on the parameter. Most adjustment

choices made with the Adjust buttons take effect immediately and will be

subsequently stored into the Ki Pro’s non-volatile memory if they remain unchanged

for 3 seconds.

If a Select or Adjust button is held down continuously, the changes will begin to

happen automatically - with acceleration if applicable.

Holding down both the Adjust (up) and Adjust (down) buttons—at the same time —

will set that parameter back to its factory default value.

The CONFIG menu is for system set-up and conﬁguration. Each parameter is

numbered, just like the MEDIA menus.

Note: The composite output on the unit follows the component output; this means that the

composite output only works if either the source format or the convert format is SD.

CONFIG Menu

Parameters

Many of the CONFIG menu parameters are used together to conﬁgure the type of Ki

Pro recording and associated conversion formats used on the input or output for a

particular workﬂow.

Before we begin listing all of the individual CONFIG menu parameters, it’s useful to

see how they can be used for an example application. Here are two examples of

making CONFIG menu selections for speciﬁc real world workﬂows.

22.1 GANG CLIP NAME Master Name (default)

Slave Name

Enable have clips named the same across all Ki Pro

ganged units

Name clips independently on Ki Pro units

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 89 90

No comments

AJA V2Analog Specifications Page 50