AJA V2Analog Specifications download pdf (Page 54)

3.2 COMPONENT OUT LVL

This parameter selects the output level for signals applied at the component video

output connectors.

Note: Setting the Ki Pro component input and/or output to "Beta" for HD material will result

in an "Invalid Selection" alarm that will need correction before recordings or other

operations may take place.

3.4 NTSC CONFIG

This parameter selects the output level for the composite video output connector.

4.1 ANALOG AUDIO

This parameter conﬁgures the analog audio signal levels for input and output.

Professional audio equipment has much higher levels than consumer equipment: a 0

VU reading corresponds to +4 dBu. Connecting a professional +4 dBu device to a

consumer audio input -10dBV (-7.8 dBu) may cause overloading, whereas the output

of a consumer device probably does not have sufﬁcient power to drive a professional

audio input. With consumer and semi-professional audio equipment, a VU reading of

0 dB is typically referenced to -10 dBV. 0 dBu = 0.775 VRMS. These settings are valid

with the panel Mic/Line switch set to “Line.” (The Mic settings are lower input level

settings for use with condenser and dynamic microphones—use Mic +48 for

powered condenser mics and Mic for dynamic microphones.)

3.2 COMPONENT OUT LVL SMPTE/N10 (default)

BETACAM

RGB

Selects SMPTE/N10 output signal levels

Selects BETACAM output signal levels

Selects RGB output signal levels

3.4 NTSC CONFIG NTSC (default)

NTSC JAPAN

Selects standard NTSC output signal levels

Selects NTSC Japan output signal levels

4.1 ANALOG AUDIO +24dBu (default)

+18dBu

+15dBu

+12dBu

Selects pro-level USA signal levels of +24dBu

Selects pro-level Europe signal levels of +18dBu

Selects pro-level German signal levels of +15dBu

Selects consumer signal levels of +12dBu

Note: Maximum amplitude (0 dBFS)

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 89 90

No comments

AJA V2Analog Specifications Page 54