AJA V2Analog Specifications download pdf (Page 29)

Ki Pro Installation and Operation Manual — Installation

Exo-skeleton Camera Mounting

Attaching the optional Ki Pro Exo-skeleton rod accessory kit is simple:

1. Open the kit box; you’ll ﬁnd preassembled endplates—these must be

disassembled before you can attached the plates to the Exo-skeleton. Place an

endplate from the kit on the outside of the Exo-skeleton frame, aligning it’s two

screw slots with the two screw holes in the frame.

2. Insert one of the supplied screws from the inside of the frame through the frame

hole and slot. While holding the screw from the inside, place a supplied washer

over the threaded end of the screw and screw one of the supplied knobs over

the end of the screw.

3. Repeat step 2 for each of the 4 knobs, washers and screws.

Once the kit is installed, you can then loosen the rod lock knobs, insert user-supplied

15mm accessory rods, and then mount any desired accessories.

To raise or lower the rods, simply loosen the rod height adjustment knobs (the ones

you installed in step 2), lift the rods to the desired height, and then tighten the knobs

once complete.

Base Ki Pro Exo-skeleton

chassis with camera mount

Knurled thumbscrews

secure Ki Pro chassis

to Exo-skeleton

Loosen

Camera

Mount

Locking

Knob

Slide Mount

off of Exo-skelton

Alignment

Mounting

Screw

Locate the Camera

Mounting screw underneath

(2 sizes provided),

align pin to Camera base

and tighten the Mounting screw

to fasten securely.

Replace Mount on

Exo-skeleton when done,

and tighten Locking Knob

to lock camera in place.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 89 90

No comments

AJA V2Analog Specifications Page 29