AJA Ki PRO rack Specifications Page 51
- Page / 111
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Ki Pro Rack v4.2 www.aja.com
51
8.1 TC VALUE
This parameter selects the starting hour for timecode when 8.0 is set to TC Value. These
are the available options:
8.2 TC TYPE
This parameter selects drop frame or non-drop frame timecode. These are the available
options:
NOTE: If the TC In is SDI RP188, LTC, or RS422, the TC Type selection does not apply. TC Type only
applies to the TC Value or the Time of Day value generated by Ki Pro Rack. These are the
available options:8.3 ARM RECORDING
8.3 ARM RECORDING
This parameter selects how recording will begin: either by pressing record button (or
web “Record” button) or via timecode. These are the available options:
If starting on timecode, parameters 8.0, 8.1. and 8.2 must be set to qualify the source and
type of timecode.
NOTE: For TC/REC KEY to operate, a record run timecode with incrementing values and starts/stops
is needed. Freerun timecode does not provide this and is not applicable to the TC/REC KEY
selection.
9.0 INTERVAL RECORD
The Ki Pro Rack can be used to create timelapse recordings via the 9.0 Interval Record, 9.1
Interval Frames and 9.2 Interval Time selections. Note that the 9.1 and 9.2 menu options
will not appear unless 9.0 Interval Record is enabled. These are the available options: .
Example of timelapse recording selections:
The incoming video signal is 1080i 29.97 fps, the record button is depressed, and the
recording is then stopped 90 seconds later with the following settings:
9.0 Interval Record > On
9.1 Interval Frames > 1
9.2 Interval Time > Second
The resulting recording would be 90 frames in duration, would have a frame rate of 29.97
fps, and would appear to be "undercranked" or "sped up" when compared to a normally
created recording.
NOTE: Selecting an interval frame number that exceeds the incoming video frames per second will
result in normal video. "Overcranking" or "slow mo" is not supported by the interval recording
feature.
00:00:00:00 to 23:00:00:00
(Default: 01:00:00:00)
Use the ADJUST buttons to select a timecode hour. For
example: 01:00:00:00, “02:00:00:00, etc.
NDF (default)
DF
Selects Non-drop Frame timecode
Selects Drop Frame timecode
REC KEY (default)
TC/REC KEY
Start when Record button is pressed
Start on Time Code trigger or Record button
OFF (default)
ON
Normal recordings are produced.
Timelapse recordings are produced.
- Version 4.2 1
- Published: September 30, 2013 1
- Table of Contents 2
- Trademarks 6
- Copyright 6
- Contacting Support 6
- Chapter 1: Introduction 7
- Features 8
- Apple ProRes 422 Advantages 9
- Avid DNxHD Advantages 9
- In This Manual 10
- Overview 11
- Operator Side 12
- Displays and Indicators 14
- Connector Side 15
- 422 devices 16
- Removable Storage 18
- Modules (HDD or 18
- Using Ki Pro Media 19
- Rack in Final Cut Pro 19
- Using Ki Pro Rack 20
- Media with Avid 20
- Media Composer 20
- Chapter 3: Installation 21
- What’s In The Box? 22
- Remote Network Control 24
- TCP/IP Information 25
- You’ll Need 25
- Networking via 25
- Networking Ki Pro 26
- Mac Ping Procedure 28
- TRANSPORT Mode (default) 30
- Recording Notes 32
- STATUS menus 33
- Alarm Status 34
- MEDIA menus 36
- Data-LAN 37
- Considerations 37
- 14.0 ENCODE MODE 37
- 14.1 ENCODE TYPE 38
- 15.1 PLAY MEDIA 38
- 15.2 LOOP PLAY 38
- 15.3 PLAYLIST 38
- 15.4 DROPPED FRAMES 38
- Custom Clip 41
- CONFIG menus 43
- 1.1 RECORD TYPE 44
- 1.3 1080p PLAYBACK 44
- 1.4 IN CONVERT 44
- 1.5 OUT CONVERT 45
- 1.6 SDI OUT 45
- 1.6 SDI 2 OUT 45
- 1.7 COMPONENT OUT 45
- 1.8 HDMI OUT 45
- 1.9 SUPER OUT 46
- 2.1 VIDEO INPUT 46
- 2.2 AUDIO INPUT 46
- 2.3 AUDIO CHANNELS 46
- 3.1 COMPONENT IN LVL 47
- 3.2 COMPONENT OUT 47
- 3.4 NTSC CONFIG 47
- 4.1 ANALOG AUDIO 47
- 4.2 AUDIO LVL L 48
- 4.3 AUDIO LVL R 48
- 5.1 UPCONVERSION 48
- 5.2 DOWNCONVERSION 49
- 6.1 GENLOCK 50
- 8.0 TC IN 50
- 8.1 TC VALUE 51
- 8.2 TC TYPE 51
- 8.3 ARM RECORDING 51
- 9.0 INTERVAL RECORD 51
- 9.1 INTERVAL FRAMES 52
- 9.2 INTERVAL TIME 52
- 13.1 CAMERA DATA 52
- IMPORTANT Notes 53
- About Cameras 53
- Supported by 13.1 53
- IMPORTANT Note 54
- About Using DNxHD 54
- Encoding with 13.1 54
- Camera Data 54
- 32.0 LOSS OF VIDEO 54
- 35.2 REMOTE CONTROL 55
- 41.1 VIDEO SG FRMT 56
- 41.2 VIDEO SG 57
- 41.3 AUDIO SG 57
- 50.1 IP CONFIG 57
- 50.2 IP ADDRESS 57
- 50.3 SUBNET MASK 58
- 50.4 STATIC GATEWAY 58
- 50.5 SYSTEM NAME 59
- 50.6 MAC ADDRESS 59
- 50.9 USER 59
- AUTHENTICATION 59
- 55.4 DATE SET 60
- 55.6 TIME SET 60
- 70.1 SCREEN SAVER 60
- Remote Control Overview 62
- Web Browser via Ethernet 62
- Update Firmware 76
- Upload and Install the 77
- Software on Your Ki Pro 77
- Advanced Features 78
- Gang Recording 80
- Working with the All 81
- Clips Playlist 81
- Creating a Playlist 81
- Playback of a Playlist 83
- Storing a Preset 83
- Recalling Presets 84
- All Clips and Media 86
- State > Data-LAN 86
- Appropriately Encoded 87
- Appendix A: Specifications 88
- Panel User Interface 89
- Timecode 89
- Serial Port 89
- Hardware Conversion 89
- Physical 90
- Canadian ICES Statement 91
- Regulatory Compliance 92
- Taiwan Compliance Statement 93
- Chinese Compliance Statement 93
- Messages 94
- Limited Warranty 108
- Limitation of Liability 109
Related products and manuals for Video capturing devices AJA Ki PRO rack
(82 pages)© 2020, manymanuals.com. All rights reserved. | 0.218 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals