AJA KONA LHe Plus Instruction Manual download pdf (Page 40)

Firmware Update Warning Screen

5. After the firmware installation completes, you’ll be asked to Shut Down the computer,

wait for two seconds, and then start up again.

Firmware Update Power-down Screen

Important: A Restart of the computer will not load the new firmware—click Shut

Down to initiate a complete ON/OFF power cycle to load the new firmware into the

hardware.

Genlock and Your System

For video stability and proper system operation, it’s always best to genlock all equipment to

house sync. Although genlock is not absolutely required for KONA LHe Plus or your system,

better quality and repeatable operation will be experienced by doing so. Usually, this means

using a black burst generator output looped through the system. On the KONA LHe cables

and optional KL-box breakout box, house sync is connected to “Ref Loop”.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 73 74

No comments

AJA KONA LHe Plus Instruction Manual Page 40