AJA KONA LHe Plus Instruction Manual download pdf (Page 19)

Chapter 2: Installation & Configuration

Installation Overview

The installation and set up of a KONA LHe Plus is very simple. All of the steps of installation

and configuration are documented in this chapter, summarized as follows:

1. Unpack the shipping box

2. If not previously installed on your Mac Pro, ensure that Final Cut Pro is installed as

detailed in its user documentation. Final Cut Pro must be installed and have been run at

least once prior to installing AJA KONA LHe Plus software.

3. For Mac Pro and LHe Plus:

Visit: http://www.aja.com/support/kona/kona-system-configuration.php

Locate your Mac model and install in the recommended slot.

4. Install AJA KONA LHe Plus software on your Mac from the

supplied AJA CD-ROM

5. Cable the system audio and video sources, VTR, audio monitor,

and video monitor. If you purchased the optional KL-box, then

install it into an equipment rack or place it on a desk and

connect its two cables to the KONA LHe Plus card. If you’re instead

using the standard cable set, then use those to connect

equipment.

Each of these steps are explained in greater detail in the remaining

pages of this chapter.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 73 74

No comments

AJA KONA LHe Plus Instruction Manual Page 19