AJA FS2 Instruction Manual download pdf (Page 71)

FS2 Installation and Operation Manual — CONFIG Menu Group

Note: Set the IP address octets (numbers between periods) as follows:

Push ADJUST momentarily to enter edit mode.

Turn SELECT to select the octet you want to edit, indicated by blinking.

Turn ADJUST to enter the new value.

Push ADJUST momentarily to save and activate the new setting.

If you need to revert to the previous setting (undo changes), push SELECT. If you want

to revert to the default value, hold down ADJUST for 4 seconds.

4.2 SNMP Trap

Port 1

This parameter determines the SNMP Trap Port 1 used for sending destination #1 trap

messages. UDP Port 162 is the default used for SNMP trap messages. However, if this

port is being used by another protocol or service, you can change the setting by

modifying this parameter. This parameter is available only if parameter 4.0 SNMP

Enable is set to On.

Note: The SNMP Trap Port number does not blink when changed (as does the Trap

Destination IP address); if you change the port number and exit the parameter, the

port changes immediately to the new value.

4.3 SNMP Trap

Destination 2

This parameter determines the secondary SNMP Trap Destination IP address where

trap messages issued by the FS2 will be sent (if desired). This parameter is available

only if parameter 4.0 SNMP Enable is set to On.

Note: Set the IP address octets (numbers between periods) as follows:

Push ADJUST momentarily to enter edit mode.

Turn SELECT to select the octet you want to edit, indicated by blinking.

Turn ADJUST to enter the new value.

Push ADJUST momentarily to save and activate the new setting.

If you need to revert to the previous setting (undo changes), push SELECT. If you want

to revert to the default value, hold down ADJUST for 4 seconds.

4.2 SNMP Trap Port 1 Selections Selection Descriptions

Variable Turn the ADJUST knob to select a UDP port for sending FS2 trap messages.

Default: 162

4.3 SNMP Trap Dest 2 Selections Selection Descriptions

IP Address Set the desired IP address where traps will be sent (usually a client on

your LAN). (See the note in 4.2 for instructions.)

Default: 192.168.0.3

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 229 230

No comments

AJA FS2 Instruction Manual Page 71