AJA FS2 Instruction Manual download pdf (Page 21)

FS2 Installation and Operation Manual — GPI Inputs and Outputs

GPI Inputs and Outputs

General Purpose Inputs and Outputs are available on the FS2 back panel to

provide contact closure control. Using the inputs, an external contact closure

activates a specified function on the FS2. Using the outputs, specific FS2 functions

can produce a contact closure to activate any desired function on external

equipment. The functions to be activated by an input or that can activate an

output are set using the front panel and browser menus. Details of GPI operation

are covered in two places:

•

Appendix B: GPI Connector Pinout describes physical connections to the GPI

outputs.

•

Chapter 4: Display Menus and Chapter 5: Browser Control describe

configuring functions to associate them with GPI inputs and outputs.

Optional Remote Control Panel

The FS2 can be controlled remotely via Ethernet using an optional remote control.

For information about which remote panels are compatible with the FS2, consult

AJA Support. See “Contacting Support” on page 2 of this guide.

Optional Fiber I/O

The FS2 supports optional AJA Optical Fiber I/O modules as follows:

•

Single Input, LC connector

•

Single Input SC connector

•

Single Output LC connector

•

Single Output SC connector

•

Dual Input LC connectors

•

Dual Output LC connectors

FS2's Fiber I/O supports the 3G/HD/SD SDI protocol. Only AJA modules are

supported; use of other manufacturers' modules is not supported and may void

the warranty.

Optional Dolby E Decoder and Encoder Cards

The current FS2 software supports a Dolby E Decoder option in the right-hand

option slot under the option top cover.

As a future option, the FS2 will accept up an optional Dolby E Encoder Card as well

as the currently available Decoder card. You will be able to install a single encoder

card and a single decoder card.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 229 230

No comments

AJA FS2 Instruction Manual Page 21