AJA V2Analog Specifications download pdf (Page 6)

V2Analog v1.0 www.aja.com

User Controls

The V2Analog converter has two user interfaces:

• DIP switch settings

• MiniConfig via USB

The DIP switch 1 setting determines which configuration parameters the converter will

use. When Off the unit is set to Local, and the DIP switch settings will be active. When On

the unit is set to Remote, and will use the MiniConfig settings. MiniConfig settings are

non-volatile and are retained through power cycles.

External DIP

Switches

The V2Analog has a 4-switch DIP accessible through a cut-out in the bottom of the unit.

For specific DIP switch setting information, see

“DIP Switch Settings” on page 8.

MiniConfig Control MiniConfig is an AJA software application used for configuring and updating the

firmware of several AJA Mini-Converter products. Configuration set via MiniConfig is

stored in the unit through subsequent power cycles. See

“USB Control and Setup—Using

AJA MiniConfig” on page 9.

Installation

Typically, V2Analog installation consists of the following:

1. Disconnect +5VDC from the converter.

2. Configure the DIP switches for the desired equipment configuration and video

formats.

3. Connect video equipment to the converter BNCs

4. Apply power to the converter (AJA power supply included).

Alternatively, you can set the unit to Remote operation using DIP switch 1, connect the

unit to a PC or Mac via USB, and then use MiniConfig to configure the unit. The

MiniConfig application is available for download from the AJA website.

NOTE: Threaded holes (unified 4-40) located on the bottom of the unit can be used for mounting.

Specifications

Formats • 525i/625i, 1080i 50/59.94/60 Hz

• 1080p, psf 23.98/24/25/29.97/30 Hz

• 720p 50/59.94/60 Hz

Inputs • HD/SD-SDI, SMPTE-259/292, 1 x BNC

Outputs • HD component YPbPr, RGB (SMPTE-274/296), BNC

• SD component (Betacam, EBU-N10)/composite/YC (S-Video), 3 X BNC

1 2 3 4 5 6 7 8 9 10 11 ... 26 27

No comments

AJA V2Analog Specifications Page 6