Aja KONA LHi User Manual download pdf (Page 55)

KONA v10.5 www.aja.com

NOTE: Be sure to set the Reference/LTC connection to Reference in the pulldown menu in the Video

Input pane.

Audio Input: This pulldown menu allows you to pick where the audio comes from. KONA supports up

to 8 channels of embedded audio. You can choose from the 16 channels embedded in

the SDI, which 8 to bring in (1-8 or 9-16). Here, if only two channels were selected in the

third-party application you are using, you can select which two channels from the 8

embedded will be mapped to that application.

SDI Output Screen The SDI Output Screen shows the current settings for both of the SDI outputs. Because

the outputs can be configured independently, one output may be the Primary format

and the other output may be the Secondary format. If an input/output has no video, it

will be indicated on the block diagram (“No Video”).

Figure 47. AJA Control Panel, SDI Output Screen

SDI Output screen

settings

Configure the SDI outputs using pulldown menus:

Primary: When selected, this indicates that the SDI output is set to the same format as the

framebuffer. That value will be listed in blue.

Secondary: When selected, this indicates that the SDI output is set to a format different from the

framebuffer (Primary Format). That secondary format value will be listed in green. This

shows that active processing of the video is taking place (format change and possibly up-

or down-conversion).

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 96 97

No comments

Aja KONA LHi User Manual Page 55