AJA HDP User Manual download pdf (Page 9)

AJA HDP HD-SDI/SDI to DVI-D and Audio Converter User Manual — Installation

Internal Jumper

To access this jumper, remove the four phillips screws securing the back side of the HDP case

(the side having the DIP switch access hole in it). Once the case cover is removed, locate the

jumpers next to the two stereo RCA audio jacks. Jumper positions 1 through 3 are clearly

marked on the circuit board next to the jumper.

Installation

Typically, HDP installation consists of the following steps:

Ensure the HDP is disconnected from power.

Conﬁgure the DIP switch for the desired conﬁguration and video scaling.

Connect video equipment to the convertor BNCs and DVI connector.

Connect audio equipment to RCA connectors (optional)

Apply +5 to +18VDC power to the converter (AJA power supply model DWP or

DWP-U).

Jumper #1 (default = removed) Jumper #2 (default = removed) Jumper #3 (default = installed)

Installed: Anamorphic SD.

SD sources will be scaled

appropriately based on 16x9 original

content.

Removed: Normal SD(default)

SD sources will be scaled

appropriately, based on 4x3 original

content.

Installed: 1080p Mode

1080p will be output when DIP switch 4

is in the ON position. This jumper has

no effect when switch 4 is in the OFF

position.

Removed: 720p Mode (default)

720p will be output when switch 4 is in

the ON position. This jumber has no

effect when switch 4 is in the OFF

position.

This jumper is provided as a spare.

Whether installed or removed, it has

no effect.

Defaults Shown Here

1=OFF, 2=OFF, 3=ON

1 2 3 4 5 6 7 8 9 10

No comments

AJA HDP User Manual Page 9