AJA KONA 3G Instruction Manual download pdf (Page 51)

KONA 3G Installation & Operating Guide — Control Panel Operation

Format Tab Screen The Formats screen shows the video format currently in use by the KONA 3G framebuffer (called

the Primary Format) and allows you to change it. All throughout the Control Panel, choices are

always presented based on what KONA 3G can do with the signals available and the inputs/

outputs selected. For example, on the Format screen, if the output or inputs are a different

format than the primary, then you’ll see an additional information pane that allows you to view

and edit the secondary format—including control over whether up/down/cross conversion is

employed.

AJA Control Panel, Formats Tab

Format Tab Screen Settings

Video Format (Primary and Secondary)—these pull-down menus show the currently selected

formats. If you select an alternate value in the Primary Format using the pull-down, it will

change the format used by KONA 3G's framebuffer. When a change is made via the Video

Format pull-down or by clicking an icon (widget) and selecting a new format via a

contextual menu, the block diagram will change to reflect the new format. In the case of a

Secondary Format, the formats available can vary based on what the Primary Format is and

the input signal (frame rates of input sources limits the to/from conversion choices). The

“Secondary Video Format” pull-down menu lists all compatible formats for selection

(incompatible formats are not shown). This allows you to see what you've chosen, and also

see those formats that are compatible with the selected Primary format.

The RGB Range pulldown menu allows you to select either Full range (0-1023) or SMPTE

range (typically 64-940) for RGB color output.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 89 90

No comments

AJA KONA 3G Instruction Manual Page 51